아래 내용은 실험1. Signal filter 내용의 일부입니다.
1. 실험 목적
본 실험의 목적은 저항과 캐패시터를 이용해 필터를 구현하고 해석하는 것이다.
2. 실험 이론
2.1 Noise의 정의와 발생이유
Noise라는 것은 한국말로 잡음이라는 의미로 보통 소음을 의미한다. 하지만 이때 소음이라고 하는
A filter is widely used in overall RF system. There are many species and structures in filter. A filter seems to be simple, but there are many considerations to design filter. In this paper, we design microstrip bandpass filter which has bandwidth of 500 MHz and center frequency of 2.5 GHz. Alumina is used as substrate, and chromium is used as conductor. Final results are achieved as follows. Ins
Design Summary
Bandpass filter using coupled line
Microstrip line
Implementation of L, C with Width & Length
Bandpass Fillter
IMT-2000 frequency bandwidth between 2.25 GHz and 2.75 GHz
Chebychev Filter
Sharp skirt characteristic
Design Procedures
Using two different equal-ripple
0.5 dB : High insertion loss
0.2 dB : More improved Insertion loss
Simulation
- 과도응답(LM833)
· 전력증폭기를 통과한 후 스피커 양단의 전압 그래프
· 약 3V의 진폭을 가지는 것을 확인
- 주파수응답(LM833)
· 전력증폭기를 통과한 후 스피커 양단의 전압 그래프
· 각 Transient Band의 기울기 약 40dB/decade확인
· HighPass & LowPass Filter가 각각 300~300kHz로 재대로 작동하는 것을