1. 실험 제목
Cantilever Beam을 이용한 Energy Harvesting Modeling
2. 이론
1) Energy Harvesting
거대 용량의 전기를 발생시키기 위한 전통적인 수력 발전, 화력 발전, 풍력 발전, 조력 발전, 태양광/태양열 발전 기술보다도 음파, 초음파, 또는 주위에서 쉽게 발생할 수 있는 소음, 떨림, 구부러짐, 수축, 신장과
Working in the static mode, the bending arises as a consequence of a surface stress change induced by any molecular reaction which takes places on only one of the cantilever surfaces. The induced surface stress change could be positive or negative, depending on the surface deformation generated. The factors and phenomena responsible for this change is today not fully understood due to the complex
3D printing
3D printing or additive manufacturing (AM) refers to any of the various processes for printing a three-dimensional object. Primarily additive processes are used, in which successive layers of material are laid down under computer control. These objects can be of almost any shape or geometry, and are produced from a 3D model or other electronic data source.
Basic principles
If the
1. 서 론
압전 재료는 기계적 에너지를 전기적 에너지로 변환시키는 압전 직접효과(piezoelectric direct effect)와 전기적 에너지를 기계적 에너지로 변환시키는 압전 역효과(piezoelectric converse effect)를 갖는 기능성 세라믹스를 지칭한다. 간단한 형상을 가지며 소형화가 가능한 압전체는 초음파 모터, 압전
캔틸레버의 탐침은 시료표면에 적용되는 힘이나 AFM의 lateral resolution을 결정.
Silicon , silicon nitride로 만듦
길이 100-200㎛, 넓이 40㎛, 두께 0.3-2㎛
표면에 수직하게 야기되는 반발력
반발력은 1~10 nN
작은 힘에도 매우 민감하게 반응하여 0.01 nm 정도로 미세하게 움직이는 것까지 측정
미세한 표면형상