analysis
★ Setup for LC/MS operation
MS
1. Turn the gas on
2. Set the capillary voltage to 2800V and desolvation temperature to 100℃
3. Turn the syringe on and make sure reference peaks are well detected
4. If necessary, calibration using NAF solution should be done.
- UPLC:
1. Turn the UV lamp on 주파장 230nm 부파장 254nm사용
2. Load the selected method
3. Sta
3. NMR
1) METHOD
★ Sample preparation
1. sample(about 10mg) dissolve in NMR solvent(Deuterated solvent) - minimum 600ul : NMR solvent 는 metanol peak 만 뜨는 문제가 있으므로 중수소화 하여 NMR에 측정 안 되는 용매를 사용.(99.95% 중수소화)
2. sample put in NMR tube
3. NMR analysis
- Locking (자장의 안전성을 확보하기 위해 - To find z0)
- Shimi
(2) GC-MS
GC-MS의 column은 DB-5MS(30 m × 250 μm × 0.25 μm)를 사용하였고, oven 온도는 40℃에서 3분간 유지한 후 분당 5℃로 250℃까지 상승시켰으며 이 온도에서 5분간 유지하였다. Carrier gas는 He을 사용하였고 유량은 1 ml/min이었으며 spitless로 하였다. 분리된 각 peak는 5 %(minimum, 가장 큰 피크의 %) 수준의 peak에 대
이름
고대이집트에서부터 사용
페퍼민트차가 가진 flavor 성분 추출
어떤 물질이 flavor를 이루는지 파악
각 flavor성분이 가지는 향기 특성 파악
추출액은 1시간 냉각 후 용매부분만 취하여Sodium sulfate로 걸러 수분을 제거하였다
질소가스 하에서 0.1 ml까지 농축하여GC-MS, GC-O 시료로 사용되었다
analysis resulted that fast pyrolysis could reduce 80% CO2 ,compared with combustion.
1. 서론
화석연료의 고갈로 인해 국제유가가 50달러에 육박하는 고 유가시대에 접어들면서, 에너지를 생산하기위해 사용되는 소모성 연료의 대부분을 수입에 의존하고 있는 우리나라의 실정에서 기존의 연료를 대체할 수 있는 에너