of the resistance read in color code. Their average error was 0.15% to 0.46%, and it was confirmed that all exist within 1%, which is the tolerance of resistance. In the second experiment, change the waveform, frequency, peak to peak amplitude, DC Offset, Voltage, and Timebase values using a function generator and oscilloscope, and compare how each parameter affects the shapeof the wave. I
of stability. So they must be attractive to investors. Especially, although Royal dutch shell has a little up and down change, it is just slight amount and absolute numerical value is higher than Chevron. So it can be said to be more attractive to investors. But Chevron is also attractive.
4. EPS
If EPS shows high ratio, the value to invest this company is increasing.
EPS is measure of retur
shaped" is the best.
And they experiment to find adequate "height and angle"
2-2. Experimental Apparatus and Measurements
*Apparatus
- heat transfer plate and side plate
- V-shaped promoter(1mm thick vinylchloride resin plate)
- fluid : water
The whole apparatus was submerged in a large water tank of 800*800mm2 in cross-sectional area and 1800mm in depth.
V-shaped promoter were located
1 and 2 was in range of theoritical value. This shows there was proper uniformity in between well attached strain gauge and cylinder.
- Shear strength compressive strength of cylinder 1 and compressive strength of cylinder 2 measured by using shear strength of cylinder.
- Dry shrinkage showed 13.56% of error by limitation ofmeasuring tools, however, we could find out shrinkage of concrete.
appreciable increase
in heat transfer rates
Present authors have proposed a unique type of promoter : "V-shaped" is the best.
And they experiment to find adequate "height and angle"
2-2. Experimental Apparatus and Measurements
*Apparatus
- heat transfer plate and side plate
- V-shaped promoter(1mm thick vinylchloride resin plate)
- fluid : water
The whole apparatus was submerged