ridge에 다 적합시킨다. 그 후 drill press 상에서 tungstencarbide drill을 사용해 설측면에다 정교한 pin hole을 여러개 형성한다.hole은 직경이 0.018~0.024인치가 괴며 깊이는 2mm이다.
4. Pin facing
- retention을 부여하는 2개의 horizontal pin을 갖는 flat back facing으로 occlusogingival space가 제한된 경우에 사용한다.
Strength of matrix MMC : Boron fiber/Al (2024) alloy
300M :
Raw material of the MMC
- Boron cost : 5000$/Kg
- Al (2024) alloy : 6000 won/Kg
300M(AMS 6417) : 168$
Produced in single-filament reactors by CVD, boron fiber exhibits a unique combination of High Strength High Modulus and Large Diameter.
Elemental boron is deposited on a fine
tungsten wire(1000~1300℃) substrate
Chapter 21 기계 가공의 기초
21.1 서론
? 절삭공정
: 칩의 생성에 의해서 공작물의 다양한 표면으로부터 재료를 제거하는 것
? 절삭공정의 종류
1. 선삭 (turning) - 공작물이 회전, 절삭 공구가 횡축 방향 이동
2. 절단 (cutting off) - 공구가 반경 방향으로 이동, 가공물 오른쪽 부분 분리 절단
3. 평밀링 (slab
Chapter 15
Extrusion and Drawing of Metals
Direct-Extrusion
Figure 15.1 Schematic illustration of the direct-extrusion process.
Extrusions and Products Made from Extrusions
Figure 15.2 Extrusions and examples of products made by sectioning off extrusions. Source: Courtesy of Kaiser Aluminum.
Types of Extrusion
Figure 15.3 Types of extrusion: (a) indirect; (b) hydrostatic; (c) lateral;
Process Var
정밀측정-로크웰 경도 시험
1. 실험 목적
경도는 변형에 대한 저항을 의미하며 금속에서 이 특성은 영구변형 또는 소성변형에 대한 저항을 측정하는 것입니다. 공학에서 널리 사용되는 압입저항의 측정을 목적으로 합니다. 충격경도시험에는 일정한 형상과 중량을 갖는 다이아몬드 해머가 일정한 높이