Examination of the microstructural image of a specimen magnified by a reflected light microscope from 50x to 1000x in air( or up to 2000x with oil immersion).
Features of metallurgical specimens such as grains, gbs, cracks, ppts can be distinguished because they differ in contrast, caused by the differences in (a) the amount of light absorbed and (b) the inclination of those atomic planes that
1.Introduction
Every creaturein the nature strives against environmental change to survive.
Some cold-blooded animals such as chameleon or cuttlefish change their body's color to surrounding color, in case of some fishes like ase cucumber, they transform theirshape under stimuli, and some creature like flytrap, they rapidly response to stimuli to prey. Those surcical instinctsclude serial proc
Fatigue Failure Process
균열발생 단계(Crack-Initiation Stage)
공업재료는 연성이며 제조한 상태대로는 균열이 존재하지 않지만, 일반적으로는 입자, 함유물 등을 포함하고 있다고 가정한다. 미시적 크기에서 금속은 균질하지도 않고 등방성도 아니다. 또한 기하학적으로 응력집중(노치)이 되는 부분이 있다
4. Condition
If reflow, IMC layer occurs between the solder ball and substrate. IMC layer's composition changes depending on reflow time.
Temperatuer
255℃
Reflow time
1s, 1min, 5min, 10min, 20min
Experimental conditions
5. Analysis
IMC layer change was observed according to the reflow time.(Reflow time : 1s, 1min, 5min, 10min, 20min). Do refer to
가바 GABA ☞
가산 모형 additive model ☞
가산 색 혼합 color mixture ☞
가산 요인 additive factors ☞
가산 차이 모형 additive-difference model ☞
가산규칙 addition rule ☞
가산성 additivity ☞
가산적 색채 혼합 additive color mixture ☞
가산적 additive ☞
가상 체험 virtual experience ☞
가상 현실 virtual reality ☞
가