Cohesion-tension Theory
Atmospheric pressure can support a column of water up to 10 meters high. But plants can move water much higher; the sequoia tree can pumpwater to its very top more than 100 meters above the ground. Until the end of the nineteenth century, the movement of water in trees and other tall plants was a mystery. Some botanists hypothesized that the living cells of plants acted a
Pump pressure
Vacuuming pressure
Coffee flow
SUCTION (or VACUUMING)
Not pushing “hot water” , But suctioning by using pressure difference
The difference is made by “Vacuum Pump”
water flows from “high P” to “low P”
What is the benefit?
- extracting coffee without water remaining on coffee particle.
- suction pressure(vacuuming
4) 장치의 설명
A. 장치의 구성 조건
장치의 중앙에 입자와 유체의 흐름을 직접보고 유체와 입자의 유동현상을 관찰할 수 있게 투명한 아크릴로 제작되었다.
유체흐름에 있어 유속의 차에 의한 압력강하 등을 측정하는 manometer가 설치되어 있으며 장치의 test section에 유체를 공급하는 waterpump와 water tank
device to use high energy.
It is non-thermal green energy machine.Indoor air conditioner outdoor unit of the hot air to absorb heat as opposed to heating, heat pumps absorb heat from the outdoor to indoor heat if heat-warming and so forth. According to the International Energy Agency (IEA), according to the heat pumpwater heater to replace the water heater is the world's CO2 8% reduce.
Waters Pump는 이러한 Pump의 요건을 갖추고 있으며 특히 Gear방식을 채택하여 pulse의 발생을 최소화하였다.
2. Waters Pump의 특징
a. 정확한 유속과 유량 조절
b. Pulse 방지를 위한 system
(Gear 방식으로 Cam 방식보다 Pulse가 적다.)
c. 가동이 쉽고 여러 용매 사용 가능.
d. Isocratic에서 Gradient까지 사용.
e. 내구성
Waters Pump의 특징
a. 정확한 유속과 유량 조절
b. Pulse 방지를 위한 system
(Gear 방식으로 Cam 방식보다 Pulse가 적다.)
c. 가동이 쉽고 여러 용매 사용 가능.
d. Isocratic에서 Gradient까지 사용.
e. 내구성이 우수.
.
.
.
HPLC grade solvent가 물인경우 18 mega ohm이상.
Low Viscosity
용매간 섞임성. (miscibility No. 차가 15
적정에 사용된 용액의 양 :
-시료 50mL
-0.1N Ba(OH)2 용액 50mL
-0.1N HCl 용액 사용
중략
실험 시 주의 사항
수위 10cm를 유지하여 정상상태를 유지한다.
Waterpump의 전원을 넣기 전 valve가 열려 있을 경우, 유량계가 깨질 염려가 있다.흡수탑의 valve들이 모두 닫혀 있는지 확인한다.
붉은색이 나타
Flow meter
Test Column
Water damper pump
Manometer tap
Manometer
유량 조절이 어렵다.
유입구 마다 유속이 다르다.
높이 측정이 어렵다.
정확한 수두차를 알 수 없다.
관의 공기를 빼내기 어렵다.
불순물이 포함되어 있다.
펌프의 문제
마노미터의 문제
실험과정
1. Water tank 내부를 깨끗이 청소한 후, 호스를 이용하여 tank의 2/3정도 물을 채운다.
2. 주의할 점은 water tank에 물이 없는 상태에서 pump를 가동하면 안 되고. 전원을 켜기 전 bypass 밸브를 개방하고 pump를 가동한다.
3. 실험 장치의 모든 valve를 완전히 열어 놓는다.
4. 실험 장치의 pump 전원을 켠다.
넘치지 않도록 gas의 양을 조절한다.)
5) Absorption column feed pump S/W를 켜고 Water 유량계를 조절하여 물이 습벽탑으로 공급되도록 한다. 유량을 높게 하여 관 안으로 흐르는 물이 골고루 퍼지도록 해준다. (관내로 물이 골고루 흐르지 않는 다면 장치의 수평을 조절하여 최대한 골고루 흐르도록 해준다.)