1. 기존 PLANT 내의 제어실에 새로운 CONTROL SYSTEM 을 설치하고 기존 CONTROL SYSTEM 과의 DATA COMMUNICATION을 하려고 한다. 이때 고려해야할 사항을 설명하시오. 또한, OSI (Open System Interconnection) 7 Layer 에 대해 설명하고 TCP/IP 4계층과 비교 및 적용되는 Protocol의 예를 드시오.
① 이기종간의 제어시스템간의 데이타
2.3 C-V graph
The measured MOS capacitance (called gate capacitance) varies with the applied gate voltage.
① Measurement of C-V characteristics
-Apply any DC bias, and superimpose a small (15 mV) ac signal
-Generally measured at 1 MHz (high frequency) or at variable frequencies between 1KHz to 1 MHz
-The dc bias VG is slowly varied to get quasi-continuous C-V characteristics
② C-V chara
4. Equipment
4.1 RCA cleaning
RCA cleaning is a series of rinsing procedure prior to experiment with Si wafer. The purpose of the RCA clean is to remove organic contaminants (such as dust particles, grease or silica gel) from the wafer surface. There are three steps to be performed. The first step is to remove organic contaminant from surface of wafer. Second step is to remove any oxide layer
Abstract- This paper presents an X-band voltagecontrolled
hairpin resonator oscillator using GaAs
MESFET varactor. To get wide tuning range, the
hairpin resonator is combined with the MESFET
varactor. It is incorporated into the series feedback
oscillator. The measurement of the oscillator
showed the frequency tuning range of 11.15 MHz
with the output power flatness less than 0.10 dB at
t
Calculation will be
10*60 parallel arrays 600mA/1A
7*3.4 series arrays 23.8V/25.4V
★LED quantity can be adjusted when it is needed
Apply the dimming system at the circuit
Reflector setting(Using mirrors and so on)
Outlet designing and scaling
Luminance examination(whether it is following industry standards)